Jumbo NanoCeram Filter System
Includes 10" Jumbo NanoCeram Insert 0.2M
and 10" Jumbo housing 3/4" Ports
(There is the option to upgrade to a bigger port size at bottom of this page)
A Revelation in Pre-Sediment Filtration !
HIGH FLOW, HIGH CAPACITY, 0.2M Pre-Sediment Pleated filter insert
For use with Ultra Violet Systems, Reverse Osmosis System, Ceramic Filters, Chlorination, Ozonation, Ultrafiltration and Microfiltration.
The NanoCeram pre-filter cartridge is designed to treat the most difficult requirements in the treatment of rainwater, borehole, well, stream, river and even canal water.
Not only is the NanoCeram filter capable of holding a high capacity of particles from 10's of microns down to an extremely fine 0.2 microns, it also allows for far higher flow rates than those of membranes or ceramic filtration.
Due to the extremely fine filtration capacity of its media, the NanoCeram will also stop some bacteria and cysts:
Cyst Retention: >5 LRV
Bacteria (Klebsiella Terringena) : > 5 LRV
Turbidity Reduction: 1.5psi @4gpm
Efficiency: 99.9% reduction of 0.2m particulate
Suggested Flow 4gmp/ 38 L/min
Peak Flow Rate 25Gpm/ 95L/min
Dirt Holding Capacity 683540mg (Based on A2 Fine Test Dust)
Temperature Range: 39-135°F ( 4-57°C)
Maximum Pressure: 70 psi (4.83 Bar)
Effective ph Range: 5-10 PH
3/4 inch port jumbo filter Housing
Ideal as inline filter housing for 22mm pipe
Heavy duty VFM Housing
Extra width housing allows for a greater flow through.
Fitted with Pressure Release button
Supplied with spanner, for fixing bracket see options below.
Inches: Diameter 4.45" X Length 9.75"
CM: Diameter 11.3cm X Length 24.8cm
Inches: Height 14" Diameter of head 71/2" Diameter at base 6"
CM: Height 35.6cm Diameter of head 19.1cm Diameter at Base 15.2cm
For more information on this filter system please see the NanoCeram Handbook link under the picture at the top of page.Email us about this product