A Revelation in Pre-Sediment Filtration !
HIGH FLOW, HIGH CAPACITY, 0.2M Pre-Sediment Pleated filter insert for use with Ultra Violet Systems, Reverse Osmosis System, Ceramic Filters, Chlorination, Ozonation, Ultrafiltration and Microfiltration.
The NanoCeram pre-filter cartridge is designed to treat the most difficult requirements in the treatment of rainwater, borehole, well, stream, river and even canal water.
Not only is the NanoCeram filter capable of holding a high capacity of particles from 10's of microns down to an extremely fine 0.2 microns, it also allows for far higher flow rates than those of membranes or ceramic filtration.
Due to the extremely fine filtration capacity of its media, the NanoCeram will also stop some bacteria and cysts:
Cyst Retention: >5 LRV
Bacteria (Klebsiella Terringena) : > 5 LRV
Turbidity Reduction: 1.5psi @4gpm
Efficiency: 99.9% reduction of 0.2m particulate
Suggested Flow 4gmp/ 38 L/min
Peak Flow Rate 25Gpm/ 95L/min
Dirt Holding Capacity 683540mg (Based on A2 Fine Test Dust)
Temperature Range: 39-135°F ( 4-57°C)
Maximum Pressure: 70 psi (4.83 Bar)
Effective ph Range: 5-10 PH
Inches: Diameter 4.45" X Length 9.75"
CM: Diameter 11.3cm X Length 24.8cm
For more information on this filter system please see the NanoCeram Handbook link under the picture at the top of page.
This filter is designed to fit inside a housing
click here for compatible Housings